Turning The Sanding Plate In 60° Increments; Working Procedures; Dust Extraction; Adapter For External Dust Extraction Systems (With Reducer) - Parkside PDS 290 B2 Manual Del Usuario

Turning the sanding plate in 60°
increments
WARNING!
► Always remove the plug from the mains
power socket before carrying out any
work on the appliance.
♦ Turn the sanding plate
in 60° increments until it clicks into the desired
position (see fig. C).
Removal and surface:
The shape of the delta sander makes it easier to
sand in hard-to-reach places, corners and edges.
The material removal rate and surface quality are
determined by the grain strength of the sandpaper
and the set oscillation speed.
■ Please note that you need to use appropriate
sandpapers with different grains for working
different materials. Also adjust the speed
depending on the material.

Working procedures

■ Switch the appliance on before applying it to
the workpiece.
■ Apply minimal pressure when working.
■ Work at a constant speed.
■ Change the sanding sheets regularly.
■ Never sand different materials (such as wood
and then metal) using the same sanding sheet
Optimum sanding results can only be achieved
by using clean sanding sheets.
■ Clean the sanding sheet
while using a vacuum cleaner.
│ GB │ MT
■ 36
on the delta sander
.
every once in a

Dust extraction

WARNING! RISK OF FIRE!
► When working with electrical appliances
which can be connected to a vacuum cleaner
via a vacuum cleaner adapter, there is a risk
of fire! Under unfavourable conditions, wood
dust in the bag of the vacuum cleaner can
spontaneously ignite. This can occur due to
flying sparks or when sanding over residual
metals in wood. This is particularly likely if
the wood dust is mixed with paint residues
or other chemicals and the workpiece has
become hot after being used for a long time.
Therefore, do not allow the material being
sanded and the appliance to overheat.
Always empty the vacuum cleaner dust bag
before taking work breaks.
Wear a dust mask!
WARNING!
► Always remove the plug from the mains
power socket before carrying out any
work on the appliance.
Adapter for external dust extraction
systems (with reducer)
Connection:
♦ Push the adapter
connection . When doing so, note the guid-
ance aids on the appliance and on the adapter.
♦ To lock, turn the extraction nozzle
♦ If necessary, use the reducer
onto the adapter
♦ Push the hose of a suitable dust extraction ap-
pliance (e.g. a workshop vacuum cleaner) onto
the adapter for vacuum extraction or the
reducer .
for dust extraction into the
clockwise.
by pushing it
.
PDS 290 B2