Flexible Shaft; Stand For The Multi-Tool - Parkside PFBS 160 B2 Traducción Del Manual De Instrucciones Original

Flexible shaft

■ Never operate the spindle lock while the motor
is running. Otherwise the appliance or the
flexible shaft could be damaged.
♦ Unscrew the union nut
appliance and store it carefully.
♦ Press the spindle lock
♦ Screw the tensioning nut
the appliance.
♦ The shaft needs to be pulled out a short distance
as it cannot be fixed into the collet chuck
otherwise.
♦ Fit the flexible shaft
To do this, the internal access of the flexible
shaft push the tensioning nut
chuck , .
♦ Press the spindle lock
♦ Now, tighten the tensioning nut
combination spanner
Now, screw the union nut
shaft clockwise onto the appliance.
♦ Place the desired accessory into the collet
chuck , of the flexible shaft.
♦ To lock the spindle, push the spindle lock
back onto the flexible shaft.
♦ Use the combination spanner
tensioning nut on the flexible shaft.
Fit the accessory and retighten the tensioning
nut .
■ 12 │ GB │ IE
anticlockwise off the
and hold it down.
anticlockwise off
,
onto the appliance.
into the collet
and hold it down.
using the
.
of the flexible
14b
to undo the

Stand for the multi-tool

♦ Screw the stand
assembly .
NOTE
► Depending on the desired attachment onto a
vertical or horizontal surface, you can screw
the stand into the clamping assembly in
two different positions.
♦ Screw the clamping assembly
of a work bench or table whose thickness is at
least 55 mm.
♦ The stand is height-adjustable. Undo the
upper part of the stand
clockwise (−). Pull out the tube to the maximum
height and lock it again by turning it clockwise
(+).
♦ The mount is also height-adjustable; turn the
black thread anticlockwise. After you have set
the mount to the correct height, tighten the
thread by turning in the opposite direction.
♦ Fix the appliance onto the mount
stand using the metal bracket
mount can be turned 360°.
into the clamping
onto the edge
by turning it anti-
of the
. The
PFBS 160 B2