Replacement Parts And Accessories - Hach TU5 Serie Instrucciones Para El Usuario

Replace the wiper
To make sure that the vial is cleaned fully, replace the wiper periodically.
1. Push menu.
2. Select SENSOR SETUP>DIAG/TEST>MAINTENANCE>WIPER REPLACE.
3. Remove the vial. Refer to steps 1 to 5 of
4. Complete the steps that show on the controller display. Install the vial wiper (silicone or fiber) that
is applicable to the sample type. Refer to the illustrated steps that follow.
The date that the wiper was replaced is automatically saved after the last screen shows.
5. Install the vial. Refer to steps 8 to 12 of
Replace the tubing
Keep water out of the vial compartment or instrument damage will occur. Before the automatic cleaning module is
installed on the instrument, make sure that there are no water leaks. Make sure that all tubing is fully seated.
Make sure that the vial nut is tight.
Replace the tubing when the tubing has a blockage or has damage.
1. Set the flow shut-off valve to off. Install the automatic cleaning module on the service bracket.
Refer to steps 1 to 3 of
2. Replace the tubing.
3. Set the flow shut-off valve to on. Make sure that there are no water leaks. Refer to steps 5B and
6B of Install the automatic cleaning module
4. Install the automatic cleaning module on the turbidimeter. Refer to step 8B of
cleaning module on page 8.

Replacement parts and accessories

Personal injury hazard. Use of non-approved parts may cause personal injury, damage to the
instrument or equipment malfunction. The replacement parts in this section are approved by the
manufacturer.
Note: Product and Article numbers may vary for some selling regions. Contact the appropriate distributor or refer to
the company website for contact information.
Replace the vial
Replace the vial
N O T I C E
Replace the vial on page 15.
on page 8.
W A R N I N G
on page 15.
on page 15.
Install the automatic
English 17