Festo 8109369 Manual De Utilización página 31

•
Caution!
– Devices with a ground connection must always be grounded.
– If a ground connection (green-yellow laboratory socket) is available, it must always be
connected to protective grounding. The protective grounding must always be connected first
(before voltage),
and must always be disconnected last (after voltage).
•
Establishing and disconnecting electrical connections
– Electrical connections may only be established in the absence of voltage.
– Electrical connections may only be disconnected in the absence of voltage.
•
Maximum permissible current loads for cables and devices must not be exceeded.
– Always compare the current ratings of the device, the connector cable and the fuse.
– In the event that these are not the same, use a separate upstream fuse in order to
provide appropriate overcurrent protection.
•
Use only connecting cables with safety plugs for electrical connections.
•
When laying connecting cables, make sure they are not kinked or pinched.
•
Do not lay connector cables over hot surfaces.
– Hot surfaces are identified with a corresponding warning symbol.
•
Make sure that connecting cables are not subjected to continuous tensile loads.
•
The device is not equipped with an integrated fuse unless specified otherwise in the technical data.
•
Always pull on the safety plug when disconnecting connecting cables – never pull the cables
themselves.
In the event of:
– visible damage,
– no function,
– inappropriate storage, or
– incorrect transport
safe operation of the device is no longer possible.
– Switch off the power supply immediately.
– Protect the device against inadvertent restart
Damage to the device cannot be repaired by the user.
Faulty devices must be returned to Festo Didactic SE for repair, or disposed of in an
environmentally responsible manner.
© Festo Didactic 8109371
WARNUNG
Starter EduTrainer
®
31