Setting The Flow Knob To The Prescribed Setting - Invacare HomeFill II Manual De Operación

oxygen level reaches 90%. Refer to Troubleshooting/ Cylinder Fill
Times on page 33 if the light does not go Off within 10 minutes.
NOTE: Refer to Troubleshooting/ Cylinder Fill Times on page 33 if
the Attention (red) light and audible alarm are on.
6. Remove the full cylinder. Refer to Disconnecting the
Cylinder from the Compressor on page 25.
7. Push the power switch to the Off (O) position.
Attention (RED Light and
Audible Alarm)
Filling (GREEN
Light)
FIGURE 4.5 Turning the Compressor On
Setting the Flow Knob to the Prescribed
Setting
NOTE: For this procedure, refer to FIGURE 4.6.
1. Attach the nasal cannula to the outlet fitting of the
cylinder.
HomeFill II Compressor
®
Control Panel
28
O Below Normal
2
(YELLOW Light)
Full (GREEN
Light)
I
O
Power
Switch
Part No 1145805