Invacare HomeFill II Manual De Operación página 23

4. To reset the connector momentarily push DOWN on the
outer ring (sleeve) of the connector fillport until GREEN
dots are visible (FIGURE 4.1).
NOTE: If the outer ring (sleeve) is in the UP position
(GREEN dots not visible), the connector fillport will be
unable to accept the cylinder fillport. Pushing DOWN
momentarily will reset the connector fillport (GREEN
dots visible) to accept the cylinder fillport.
PUSH
DOWN
GREEN Dots
FIGURE 4.1 Resetting Connector Fillport
5. Grasp the cylinder/regulator assembly in the area behind
the cylinder gauge (FIGURE 4.2).
6. Position the cylinder in the compressor cradle (FIGURE
4.2).
7. Align the cylinder fillport with the connector fillport
(FIGURE 4.2).
8. Pull UP on the outer ring (sleeve) of the connector fillport
while pushing DOWN on the cylinder/regulator assembly
to couple the cylinder fillport into the connector fillport
(FIGURE 4.2).
NOTE: An audible "click" indicates that the cylinder is properly
connected.
Part No 1145805
Outer Ring (Sleeve)
BEFORE COUPLING
THE CYLINDER,
PUSH DOWN ON
THE SLEEVE UNTIL
THE GREEN
DOTS
ARE VISIBLE.
23
Connector Fillport
HomeFill II Compressor
®