Cutting Performance - Textron Jacobsen RANSOMES LH Serie Manual De Seguridad Y Operacion

GB-FR-NL-32
All manuals and user guides at all-guides.com
GB
TRANSPORTING
1. Move the cutting cylinder control lever to
neutral.
2. Raise the machine fully by operating the tractor
lift quadrant lever.
3. Put the tractor P.T.O drive in neutral to avoid
unnecessary circulation of oil in the hydraulic
system.
It is imperative that the P.T.O. drive is disengaged and
the valve control lever is in neutral before the machine
is lifted.
No automatic cut out of the hydraulic drive is provided
and damage will occur to the machine components if
the P.T.O. is not disengaged.
IMPORTANT: The tractor P.T.O. drive MUST NOT be
re-engaged until the machine is returned to the cutting
position.

CUTTING PERFORMANCE

NOTE: Due to the low power requirement of the
Mounted 214, it is quite acceptable to use the tractor
with the engine speed reduced to as low as 900 rpm.
This may be necessary when sparse grass of uneven
height is being cut. It is also convenient for
manoeuvring, reduces noise and improves operator
comfort, and reduces tractor engine wear.
Slow cutting cylinder speeds reduce cylinder and
bottom blade wear.
It is necessary to use increased engine speeds to
achieve satisfactory cutting and grass discharge in
wet, lush grass conditions or where higher cuts/yard
are required at reasonable forward speeds.