Tabla de contenido
Publicidad
Fig. 16
Fig. 17
GB-FR-NL-52
All manuals and user guides at all-guides.com
GB
ADJUSTMENTS
Read the safety instructions
HEIGHT OF CUT ADJUSTMENT
The height of cut can be set from 12mm (15/32 in) to
85mm (3 11/32 in).
There are two methods of adjustment.
Method 1. For quick adjustment. (Fig 16).
Three settings at 62mm (2 7/16 in), 73mm
(2 29/32in), 85mm (3 11/32in) maximum intervals are
provided in the mounting bracket (A).
To adjust:
(a)
Slacken the nut and bolt (B) until the locating
collars (C) are free.
(b)
Move the cutting unit up or down to the
required setting and tighten the nut and bolt
securely.
Method 2. For finer adjustment (Fig. 17)
When the mounting brackets are positioned in the
lower setting the height of cut can be adjusted from
12mm (15/32in) up to 63mm (2 31/64in) by means of
the rear roll adjusters. To adjust:
(a)
Slacken the screws (B) which clamp the skids to
the side frames.
(b)
Turn the adjusters (A) clockwise to reduce the
height of cut, and anticlockwise to increase the
height of cut.
(c)
Tighten the screws securely. Adjust both sides
equally.
VERTICUT REEL ADJUSTMENT
The position of the reel must nit be altered after being
set. Any changes required in height must only be
made by moving the front and rear rolls. Normal
settings of the blades is that the tips should be 3mm
(1/8in) above the ground. The blade tips MUST NOT
penetrate the top surface of the soil.
To adjust:
1.
Release bolt and nut at front end.
2.
Turn adjusters above rear roll clockwise to
reduce height of cut and anticlockwise to
increase height of cut.
3.
re-tighten nut at front of skid.
Publicidad
Tabla de contenido
