Tabla de contenido
Publicidad
Fig. 7
Fig. 8
Fig. 9
Fig. 10
GB-FR-NL-44
All manuals and user guides at all-guides.com
GB
LUBRICATION
Read the safety instructions
For recommended lubricants see specification
Should the number of working hours that the machine
is in use during the indicated period exceed the
number quoted in brackets, then use the
recommended 'working hour' guide as the lubrication
schedule.
Before using the machine for the first time:
1.
Lubricate all points.
2.
Check, and if necessary fill the pump gearbox
to the correct level.
3.
Check and, if necessary, fill the hydraulic tank
with Shell Tellus 46 oil (I.S.O. viscosity grade)
unit the level of the oil is midway up the filler
filter (A fig. 7). Circulate the oil through the
hydraulic system, re-check the oil level and top
up, if necessary.
4.
Lubicate both ends of the Power Take Off shaft
where it connects to the tractor PTO and the
pump drive gearbox with Rocol Anti-sieze (dry
Molybdenum) paste.
Daily (Every 8 working hours)
Lubricate the trailing arm spherical bearing (unit
number 1, centre) using Rocol GP 1 grease.
Weekly (Every 40 working hours)
1.
Lubricate the rear rolls (A Fig. 8) with shell
"Retinax A" grease, or equivalent - rotate the roll
continuously during the lubrication.
NOTE: Lubricate more frequently in very wet or dusty
conditions.
2.
Lubricate the following points using S.A.E. 30 oil
or Shell Retinax A grease.
(a)
Cutting cylinder bearing housing pivots
(C Fig. 8)
(b)
Height adjustment tubes (B Fig. 8).
(c)
Pivot brackets (B Fig. 9).
3.
Lubricate the following points using Rocol Anti-
Seize:
(a)
Cutting cylinder adjusting screws
(E Fig 10).
(b)
Cylinder adjuster clamp pivot (F Fig. 10)
Publicidad
Tabla de contenido
