Installing The Rf Remote Control And Receiver; Placing The Rf Receiver On The Base Frame; Attachment Of The Handset - Auping AVS 455 Manual De Instrucciones

3.4 Installing the RF remote control
and receiver*
Press the connect button on the
receiver for 5 seconds. The green light
will start blinking. Press any button on
the remote control, for adjusting the
bed, until the green light stops blinking,
indicating the remote control and
receiver are connected now. The bed
base can now be adjusted with the
remote control. Please repeat this
procedure for the remote control and
receiver for a second bed base if
applicable.
3.5 Placing the RF receiver on the base
frame*
Remove the protective foil
from the adhesive tape
and place the receiver on
the bottom of the base
frame near the side of the
bed, for the
reception.
best
Place the receiver at the same tube that
holds the control unit.
Secure by using the tie-wrap around
receiver and steel tube.

3.6 Attachment of the handset

In order to easily
attach the handset
to Auping Auronde,
Match or other bed
model.
• Place the clamp
on the underside
of the side panel
of the surround
(see fig. 1).
• Click the handset
into the clamp.
* If applicable.
fig. 1
GB23