Getting Started; Install The Batteries; Insert A Memory Card - Coby Snapp CAM4002 Manual De Instrucciones

getting started

Â
Please read and complete the following steps to
begin using your digital video camera.

Install the Batteries

1. Remove the battery compartment door by slid-
ing it toward the base of the camera.
2. Load three "AAA" batteries into the compart-
ment as shown in the diagram.
3. Replace the battery compartment door.
Getting Started Getting Started
All manuals and user guides at all-guides.com
The battery used in this device may present
a fire or chemical hazard if mistreated. Do
not recharge, disassemble, incinerate, or
heat the batteries. Used batteries should be
disposed of safely.
Replace all batteries at the same time. Do
not mix old with new batteries. Do not mix
different types of batteries.
Keep batteries out of the reach of children.

Insert a Memory Card

This camera records to SD or SDHC memory cards.
The maximum supported card size is 16GB.
Make sure that the write protection switch on the

memory card is set to the "unlocked" position.
Page 9 Page 9