Battery Packs; Charging Procedure - DeWalt DW974 Manual De Instrucciones

385360/DW974 etc 5/2/02 11:25 AM
DW9115
15 MINUTE
CHARGER
FIG. 1

Battery Packs

Your tool uses a 12.0 Volt or a 14.4 Volt D
ordering replacement battery packs, be sure to include catalog
number and voltage: (12.0 Volt-DW9071) (14.4 Volt-DW9091 or
DW9092). XR PACK™ Extended Run-Time battery packs deliver
25% more run-time than standard battery packs. NOTE: Your tool will
accept either standard or Extended Run Time battery packs.
However, be sure to select proper voltage.
All manuals and user guides at all-guides.com
Page 3
Chargers DW9104, DW9106, DW9107,
DW9115
Your battery can be charged in the DW9104, DW9106, DW9107(1
Hour Chargers),or the DW9115 (15 Minute Charger) Be sure to read
all safety instructions before using your charger.

Charging Procedure

These chargers require no adjustment and are designed to be as
DW9104,
easy as possible to operate. Simply place your battery pack into the
DW9106 1 HOUR
receptacle of a plugged in charger (FIG.1) and it will automatically
CHARGERS
charge the pack.
DW9104/DW9106/DW9107 (1 HOUR CHARGERS)
1. Plug the charger into an appropriate AC power outlet.
2. Insert the battery pack into the charger, as shown in FIG.1,
3. The battery pack will be fully charged in about 1 hour. The
DW9115 (15 MINUTE CHARGER)
DW9107
1. Plug the charger into an appropriate AC power outlet. The charger
1 HOUR CHARGER
2. Insert the battery pack into the charger, as shown in FIG. 1,
WALT battery pack. When
E
3. The battery pack will be fully charged in less than 15 minutes
3
making sure the pack is fully seated in the charger. The red
(charging) light will blink continuously indicating that the charging
process has started.
completion of charge will be indicated by the red light remaining
ON continuously. The pack is fully charged and may be used at
this time or left in the charger.
will beep twice, the red light will blink and go off.
making sure the pack is fully seated in the charger. The red light
will blink and the charger will beep once indicating the charging
process has started.
under most conditions. This will be indicated by the red light
remaining ON and 3 beeps. The pack is fully charged and may
be used at this time or left in the charger.