KTM 60714910133 Manual Del Usuario página 12

12
All manuals and user guides at all-guides.com
- Position the fuel tank.
- Mount screw
to 15 Nm.
- Plug in connector
- Mount vent hoses
- Mount cable tie(s).
- Mount screws
Mount switch
- Drill mounting holes (Ø 22 mm and Ø 5 mm) using appropriate tool.
NOTE
The positions are market on the trim.
When drilling, make sure that none of the components are dam-
aged!
- Position switch housing
- Route through the hole.
- Position clamp
- Mount and tighten screws
- Join plug-in connector
- Route the cable without tension.
Ensure that the cables are not kinked or pinched!
with bearing sleeve and rubber bushing and tighten
.
and .
with bushings on both sides and tighten to 10 Nm.
with switch (included).
(included).
(included).
together.