CLEAN & CARE
Clean the Air Filter
1. Reinstall the dried filter in reverse order of removal, then cover and
lock the panel.
Check Before Use
1. Check whether all the air inlets and outlets of the units are unblocked.
2. Check whether there is blocking in the water outlet of the drain hose,
and immediately clean it up.
3. Check that the ground wire is reliably grounded.
4. Check whether the remote control batteries are installed and whether
the power is sufficient.
5. Check whether there is damage in the mounting bracket of the
outdoor unit, and if any, please contact a local service center.
Maintain After Use
1. Turn off the power source of the air conditioner, turn off the circuit
breaker and remove the batteries from the remote control.
2. Clean the filter and the unit body.
3. Remove the dust and debris from the outdoor unit.
4. Check whether there is damage in the mounting bracket of the
outdoor unit, and if any, please contact a local service center.
Page 46