Use And Care Of The Remote Control; Installing The Battery; Using The Remote Control; Resetting The Microprocessor - Pioneer DEH-P65BT Manual De Operación

Before You Start
Use and care of the remote
control

Installing the battery

Slide the tray out on the back of the remote
control and insert the battery with the plus (+)
and minus (–) poles pointing in the proper di-
rection.
! When using for the first time, pull out the
film protruding from the tray.
WARNING
Keep the battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.
CAUTION
! Use only one CR2025 (3 V) lithium battery.
! Remove the battery if the remote control is not
used for a month or longer.
! Danger of explosion if battery is incorrectly re-
placed. Replace only with the same or equiva-
lent type.
! Do not handle the battery with metallic tools.
! Do not store the battery with metallic materi-
als.
! In the event of battery leakage, wipe the re-
mote control completely clean and install a
new battery.
! When disposing of used batteries, please
comply with governmental regulations or en-
vironmental public institutions' rules that
apply in your country/area.

Using the remote control

Point the remote control in the direction of the
front panel to operate.
! The remote control may not function prop-
erly in direct sunlight.
All manuals and user guides at all-guides.com
Important
! Do not store the remote control in high tem-
peratures or direct sunlight.
! Do not let the remote control fall onto the
floor, where it may become jammed under the
brake or accelerator pedal.

Resetting the microprocessor

The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
1 Remove the front panel.
Refer to Removing the front panel on the pre-
vious page.
2 Press RESET with a pen tip or other
pointed instrument.
RESET button
3 Replace the front panel by clipping it
into place.
Section
01
7
En