Heat Settings - Jocel JAG014146 Manual Del Usuario

GAS HEATER OPERATION GUIDE
Pos. 1 Pos.2
(Lighting) (Minimum)
Pos.3 Pos.4
(Medium) (Maximum)
1. LIGHTNG INSTUCTION
a. The heater has three settings. Lighting (Pos.1) and Minimum (Pos.2); Medium (Pos.3) and Maximum
(Pos.4)
b. Place the gas filled cylinder into the back of the heater.
c. Clip on the gas regulator to the gas cylinder.
d. Turn on the gas regulator.
2. LIGHTING
Press the control button for 10 seconds at the Position 1, at the same time press the piezo igniter key to
light with thumb finger of left hand, continue this procedure until pilot ignites, approximately after 20
seconds leave control button. At this stage if the pilot is alight, it means that the heater is at the minimum
position (Pos.1). If the pilot flame goes out please repeat this procedure.

3. HEAT SETTINGS

To change from minimum to maximum gently press control button and turn it to position 3.
To change from maximum to medium gently press control button and turn it to position 2.
4. TURN OFF THE HEATER
Turn and press the control knob to LIGHTNING position. Then turn off the valve on the gas cylinder. If
the heater is not used for a period of time, disconnect the regulator from the cylinder.
- 34 -