Assembly Diagram - HAMPTON BAY 828-359 Manual De Instrucciones

end of track. Tighten set screws.
6. Place track connector assembly against ceiling aligning the center of the
connector to center of the junction box. Mark track holes and proceed with
installation as described in track installation instructions.
7. Remove the connector cover. Make electrical connections. Attach the white
(neutral) wire from the outlet box to the silver screw from the live end
connector; Attach the Black (Hot) wire from the outlet box to the brass screw
from the live end connector; Attach the Green or bare copper (ground) wire
to the green screw from the live end connector. Replace the connector cover.
8. Push the cover into track. Tighten set screws.

ASSEMBLY DIAGRAM:

Ceiling outlet Box
Mounting plate
Mounting screws
Connector
Track
White wire
Silver screw
Connector cover
Black wire
Ground wire (bare or green)
Brass plated screw
Ground screw
Cover plate
3