60313.16.03
Folder Options (Fixed Speed)
Home folder
Page 1: System Overview
Figure 32: Home Folder
This is the factory default display after powering up the system.
•
Online Pressure Setpoint is indicated in the white box and by the white
arrow, which is always left of center on the gauge.
•
Offline Pressure Setpoint is indicated in the white box and by the white
arrow, which is always right of center on the gauge.
Package Discharge Pressure is indicated by the large numbers centered
•
below the gauge and by the red arrow.
•
Pressure Unit of Measure is indicated below the Package Discharge
Pressure. This is selectable from the General Settings folder.
•
Airend Discharge Temperature is indicated by the numbers in the lower
left of the display.
Temperature Unit of Measure is indicated to the right of the Airend
•
Discharge Temperature. This is selectable from the General Settings folder.
Run Hours indicate the number of hours the compressor has been
•
running.
The online and offline set points can be selected and modified on this
page . All other information on this page is read only .
Page 2 : Counters
•
Hour Meters indicate the hours that: the controller has been powered
up, the compressor has been running, and the compressor has running
loaded.
•
Starts indicate the number of times a start is attempted on the
compressor.
Date & Time is adjustable and configurable in the General Settings folder.
•
EN-
All manuals and user guides at all-guides.com
NOTICE
Figure 33: Counters
Pages 3-4: Analog Inputs
Figure 34: Analog Inputs
Icon
NOTICE
All information on these pages is read only .
The following inputs are displayed in this section:
•
Package Discharge Pressure
•
Sump Pressure
•
Airend Discharge Temperature
•
Injected Coolant Temperature
•
Aftercooler Discharge Temperature
•
Separator Pressure Drop
•
Coolant Filter Pressure Drop
•
Inlet Vacuum
•
Aftercooler Discharge Pressure (integrated dryer compressors only)
•
Remote Pressure (optional)
EN
Meaning
Pressure
Temperature
80446339 Rev C