Factory Settings Folder - Ingersoll Rand R37-160 Información Del Producto

60313.16.03
Pages 7-8: Digital Outputs
Figure 53: Digital Outputs
A marked checkbox beside a digital output indicates that it is energized.
• Starter Contact 1
• Starter Contact 2
• Fan Starter Contact
• Blowdown Solenoid
• Modulation Solenoid
• Condensate Drain
• Dryer Run / Fan Run
• PORO Horn
• Trip Relay
• Warning Relay
• Low Voltage Output 1
• Low Voltage Output 2
• Low Voltage Output 
• Low Voltage Output 4
(RO) indicates read-only values .
Page 9: Analog Outputs
Figure 54: Analog Outputs
The value for the analog outputs will be in mA.
• VSD Blower Output
• Analog Output 2
(RO) indicates read-only values .
EN-9
All manuals and user guides at all-guides.com
NOTICE
NOTICE

Factory settings folder


This folder is for factory and service personnel. A password must be entered
on page one in order to adjust values in this folder. This folder is used for
setting parameters that are specific to that compressor and displaying
software information for the controller.
Page 1: Password
Figure 55: Password
Table 21: Password
Display Text Description
Password Provides access to enter a valid password to gain access
to password protected parameters. The password is
entered by scrolling down to the password value and
pressing the RETURN key.
Password This checkbox will indicate a valid password has been
entered entered. If this checkbox is blank, a valid password has
not been entered or it has timed out. This is read only.
Password Checking this box will enable the password time feature.
timeout
enable
Password This timeout along with the password timeout enable
timeout allows the user to set an adjustable amount of time
to require a valid password to be re-entered. Once
this timeout is reached re-entry of a valid password is
required.
EN
80446339 Rev C