Reset To The Factory Settings; Measuring Time; Measuring Range; Led Signals - Dräger PID 5000 Instrucciones De Uso

en
Operation
steps of 0.01, taking into account that a value greater than
1.6 mg/m³ is not permitted due to the set measuring range
of 0-1.6 mg/m³. Confirm with "accept".
6. Select "ALARM HI" (main alarm) and
adjust by tapping on "more" or "less".
The main alarm can be adjusted
between 0.20 and 10.00 mg/m³ in
steps of 0.01, taking into account that a value greater than
1.6 mg/m³ is not permitted due to the set measuring range
of 0-1.6 mg/m³. Confirm with "accept".
4.3.3

Reset to the factory settings

NOTICE
When resetting to the factory settings, all changes made,
such as adjustments to the response factor, are reset. In
addition, the PID 5000 must be recalibrated.
The PID 5000 can be reset to the factory settings as described
below.
1. Select the instrument menu (see chapter 4.3 on page 21).
2. Use the magnetic pen to tap on "menu" until "RESET"
appears on the display.
3. Select "run". The PID 5000 is reset to the factory settings.
24
4.4

Measuring time

The PID 5000 determines the concentration by calculating the
difference between the two gas inlets (measurement and
reference). To do so, the PID 5000 automatically switches
between both inlets. The switching interval is 20 seconds for
the gas inlet measurement and 40 seconds for the gas inlet
reference. The PID 5000 has a measurement delay / response
time of at least 60 seconds because of the duration of the
measurement.
4.5

Measuring range

Signal range (isobutylene equivalent)
Resolution
Recommended span gas for calibration
Full scale deflection
4.6

LED signals

Status
Commissioning
Menu
Gas inlet measurement
(measurement)
0 to 1.6 mg/m³
0.01 mg/m³
5 ppm isobutylene
1.6 mg/m³
Alarm Alarm Status
LO LED HI LED LED
Off Off Flashing
white
Off Off Blue
Off Off Green