For Your Safety; Follow Instructions For Use; Maintenance; Accessories - Dräger UCF 6000 Instrucciones De Uso

For your safety

1 For your safety
1.1

Follow instructions for use

Any use of the thermal imaging camera requires full understanding
and strict observation of these Instructions for Use. Dräger recom-
mends additional theoretical instructions and a profound practical
training on the use and operation of the thermal imaging camera. The
thermal imaging camera is only to be used for the purposes specified
(see chapter 3.4 on page 30).
1.2

Maintenance

The thermal imaging camera is maintenance-free. However, it should
be inspected for proper functioning on a regular basis. Only personnel
that is trained accordingly may check, repair and maintain the product
as described in these Instructions for Use. Maintenance work which is
not described in these Instructions for Use only must be carried out by
Dräger or by specialized personnel trained by Dräger.
1.3

Accessories

Only use accessories listed in the order list.
1.4

Safe coupling with electrical devices

Electrical connections to devices which are not listed in these
Instructions for Use should only be made following consultations with
the respective manufacturers or an expert. If other components are
used, the inherent safety of the camera may be compromised.
24
1.5

Use in areas subject to explosion hazards

Devices or components for use in explosion hazard areas which have
been tested and approved according to national, European or interna-
tional Explosion Protection Regulations may be used only under the
conditions explicitly specified in the approval documents and under
consideration of the relevant legal regulations.
The device or components may not be modified in any manner.
The use of faulty or incomplete parts is forbidden. The appropriate reg-
ulations must be observed at all times when carrying out repairs on
these devices or components.
If the camera is marked for group I (mining), it may be used in
applications where coal dust can be deposited in layers. The maximum
surface temperature of the camera is 130 °C (266 °F) even if a device
fault should occur.
1.6 Safety symbols used in these instructions for
use
While reading this manual, you will come across a number of warnings
concerning some of the risks and dangers you may face while using
the device. These warnings include signal words which will alert you to
the degree of hazard you may encounter. These words, and the haz-
ard they describe, are as follows:
Dräger UCF 6000/7000