Fixing The Coffee Maker - Dometic WAECO PerfectPower PP402 PAD Instrucciones De Uso

Fixing the coffee maker

Fasten the inverter as follows (fig. 5, page 4):
➤ Clip two holders on the lower left bar and two on the right.
You can move the holders as required.
➤ Fasten the inverter by screwing one screw through each hole in the
holders.
6.2 Connecting the inverter
A
NOTICE!
 Only extend the connection line with cables with an equal or
greater cross section.
 Do not reverse the polarity. Reversing the polarity of the con-
nections will cause a great spark and the internal fuses will melt.
➤ To set up the inverter, connect the red cable (fig. 1 4, page 3) to the pos-
itive pole (+) of the battery and the black cable (fig. 1 5, page 3) to the
negative pole (–) of the battery. Make sure the battery poles are clean
when connecting the terminals.
7 Fixing the coffee maker
➤ Fasten the velcro strip to both sides of the coffee machine (fig. 6,
page 5).
➤ Choose a suitable installation surface for the bracket:
– The installation surface must be level and sufficiently sturdy.
– Make sure that you can lay the connection cables.
– Make sure that you don't damage parts by the installation.
➤ Fasten the bracket by screwing one screw through each hole (fig. 7,
page 5).
Fixing the coffee maker (fig. 8, page 5)
➤ Pull the locking plate forwards and keep it pulled (A).
➤ Put the coffee maker upon the bracket (B).
➤ Push back the locking plate (C).
28
PP402 PAD, PP404 PAD
EN