Sauder 423392 Instrucciones De Montaje página 20

Step 16
1
BROWN 1" FLAT HEAD SCREW
L
K
å
Fasten the DRAWER FRONT (L) to the DRAWER
FRONT MOLDING (K). Use two BROWN 1" FLAT
HEAD SCREWS (12S).
å
NOTE: Do not overtighten the SCREWS into the
DRAWER FRONT MOLDING.
3
U n fi
n i s h
D701
D12
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D701) into the
grooves in the DRAWER SIDES (D12 and D13) and
DRAWER FRONT (L).
Page 20
(2 used in this step)
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
e d
s u r
f a c
e
D13
L
2
12S
Groove
å
Insert the DRAWER SIDES (D12 and D13) at an angle
into the slot at each end of the DRAWER FRONT (L).
4
D12
å
Fasten the DRAWER BACK (D62) to the DRAWER
SIDES (D12 and D13). Use four BLACK 1-9/16" FLAT
HEAD SCREWS (30S).
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D12
D13
L
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
D62
D13
30S
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.