Select Range For The Input Signal - Kübler CODIX 550 Manual Del Usuario

Where negative values are permitted, the highest
digit will switch from "9" to"–" and only then to
"0".
5.2 Input Parameters for Instantaneous value
All set-ups related to the input signal and the
corresponding displayed value are carried out
here.

5.2.1 Select range for the input signal

Menu <–> Selection
press the key to accept the selection
5.2.2 Set the decimal point for the Instantaneous value
Menu <–> Selection
press the key to accept the selection
10
Display range
(–0,500 ... 10,500)
2 ... 10 V (01,500 ... 10,500)
-10 ... +10 V (–10,500 ... 10,500)
0 ... 20 mA (–01,000 ... 21,000)
4 ... 20 mA (03,000 ... 21,000)
0 ... 10 V (–0,500 ... 10,500)
Range
–19999 ... 99999
0,0 –1999,9 ... 9999,9
0,00 –199,99 ... 999,99
0,000 –19,999 ... 99,999
0,0000 –1,9999 ... 9,9999
Press the key to switch to the next digit.
Enter value: Press the
will be stored. The next menu item
appears.
The displayed value is displayed from the input
signal via the scaling slope.
The position of the decimal
point has no influence on the
measuring accuracy. The
maximum display value must
be within the display range.
After the decimal point is set
up, the leading zeros in the
display will be suppressed.
key, the value
www.kuebler.com