Kübler CODIX 550 Manual Del Usuario página 37

6. Operation
The unit is in the operating mode, when the
power supply is switched on or at the end of the
set-up.
326.81 The measuring signal has
been applied and lies within the
limits of the measuring range. The
display will show either the current
The input value is below the lower
limit of the measuring range. This
message alternates with the cur-
The input value is higher than the
upper limit of the measuring
range. This message alternates
The input value is less than -13.6
V. Current inputs below 0.0 mA are
not measured.
The input value is higher than 11.0
V or above 21.5 mA
18
One of the following will be displayed during op-
eration.
measured value, the totalizer
value, the MAX value or the MIN
value.
rent measured value or with the
value of the totalizer.
with the current measured value or
with the value of the totalizer.
www.kuebler.com