Scaling Slope; Setting The Scaling Slope - Kübler CODIX 550 Manual Del Usuario

5.2.4 Changing the Scaling Slope
Menu <–> Selection
press the key to accept the selection

5.3 Setting the Scaling Slope

At least two points (2 pairs of value) for the start-
ing and the end points respectively of the char-
acteristic curve are reqquiered. The curve can be
ascending or descending.
At least two points (2 pairs of values) are re-
quired for the start point and end point of the
scaling slope. This slope can be rising or falling.
A maximum of 24 scaling points can be used.
Input range 0 ... 10 V, 2 ... 10 V, 0 ... 20 mA, 4 ... 20 mA
12
Example: Yes
use the scaling slope curve,
Enter or alter scaling slope curve
É
Chapter 5.4,
É
Chapter 5.3,
However it should be noted that in all cases,
whether the slope rises or falls, the values
that are inputted (Inp.01 ... InP.24) must in-
crease sequentially.
The scaling slope must lie within the limits of the
input and display ranges. The first and last
points can lie on the limits.
Display range
14
12
www.kuebler.com