Resistance Measurement - Greenlee 93-804 Instructivo De Operacion, Servicio Y Piezas

Resistance Measurement

Never connect a source of voltage with the Range Selector Switch in the
Ω (ohms) position. Personal injury or damage to the meter may result.
Failure to observe this warning may result in severe injury or death.
1. Turn off device being tested. Discharge any capacitors. Voltage should not be
present.
2. Connect the red test lead to the + input terminal and the black test lead to the
- input terminal.
3. Set the Range Select Switch to the 2KΩ Resistance Range.
4. Connect the test leads across the resistance being measured and read the
display. Press DATA HOLD to hold displayed range. Press again to release.
Note: Resistance readings should always be taken in parallel with the circuit.
8
All manuals and user guides at all-guides.com