USAGE INSTRUCTIONS
NOTHING'S EASY AT FIRST ...
... most accidents happen to "beginners" within the first ten minutes.
Particular care should be taken during this stage.
DRIVING INSTRUCTIONS
The scooter moves when a foot is used to regularly push off, just as
with well-known children's scooters. Braking is no problem either -
simply step on the friction brake over the back wheel (mudguard).
We recommend folding the scooter by hand after each use or using
the stand. The side stand is in the direction of movement located on
the left hand side under the deck. Its use is ensured through simply
folding and unfolding. Aluminium is a good and light material but
should also be handled carefully as it is not as hard as steel, for
example.
MAINTENANCE AND STORAGE
Use a dry or damp cloth only to clean the product; do not use special
cleaning agents! Check the product for damage or traces of wear and
tear before and after each use. Do not make any structural changes.
For your own safety, please use original spare parts only. These can
be sourced from HUDORA. If parts become damaged or if sharp
edges or corners should develop, the product may not be used any
more. If in any doubt, please contact our service team (www.hudora.
de). Store the product in a safe place where it is protected from the
elements, cannot be damaged, and cannot injure anyone.
Replace damaged or worn assembly parts in order to ensure the
safety of your scooter.
WHEEL CHANGE
Replacement wheels are available as accessories from www.hudora.
de and should be replaced when they are worn down. To change
the wheels, loosen the axle fitting with two Allen keys and take the
wheels off the axle. A screwdriver or Allen key can be used to push
the bearings out of the wheel to use them in the new wheel. However,
it is usually advisable to change the bearings when the wheels are
changed. Put the bearings into the new wheel with the bolt spacer
and mount them to the frame with the axle screws. Make sure the
axle has been screwed on tightly before starting again!
BEARINGS
Your kick scooter is equipped with precision ball bearings, which
were filled with grease under high pressure, during manufacture. For
this reason, the rollers of the kick scooter only run lightly and swiftly,
while under load. Bearings are maintenance-free, but they are wear
parts. Caution! Worn bearings make conspicuous audible noises
and their function is constrained. In order to maintain optimal riding
pleasure and to ensure lasting safety, you should replace bearings,
as soon as they begin to exhibit signs of being worn. In the case of
full load and daily use we recommend the replacement of the rollers
and bearings twice a year. Bearings are available as accessories
under www.hudora.de.
DISPOSAL ADVICE
At the end of the product's life, please dispose of it at an appropriate
collection point provided in your area. Local waste management
companies will be able to answer your questions on this.
SERVICE
We make every effort to deliver faultless products. If faults do arise
however, we put just as much effort into rectifying them. Therefore,
you can find numerous information on the product, replacement
parts, solutions to problems and lost assembly manuals at
www.hudora.de.
SPARE PARTS AND ORIGINAL
ACCESSORIES AVAILABLE AT:
www.hudora.de
All images are examples of the design.
7/24