Installation And Set-Up - Glatz Suncomfort Gastrofit Manual De Instrucciones

Installation and start-up
1
4×
4×
2
3
Click
Unpacking the sunshade
Supplied with:
- Upper pole with sunshade canopy
- Lower pole
- Operating instructions
Optional:
- Cross base with stand pipe, mounting
material, protective cover
!
Dispose of packaging material proper-
ly and keep away from children.
Do not make use of defective material.
In the event of any damage, inform the
transport service provider immediately.
Placing the sunshade down
!
Carefully place the sunshade on
a clean, horizontal surface. The
sunshade is very heavy. Work in a
threesome and hold the sunshade
securely.
Put the sunshade together
1. Fasten the lower pole into the top
pole
2. Click ratchet pins into place
!
Caution: Ensure that the ratchet
pins have clicked into place!
36 37
4.1
4.2
4.3 ... 4.6
5.1
5.2
4
Prepare the floor fastening
Floor fastening weights and wind
resistance
Size minimum weight
[cm] [kg]
40 x 40 x 4 120
40 x 40 x 4 180
1. Mount cross base
2. Place the base plate and fix it with 4
countersunk screws
3. Place stand pipe on cross base
4. Adjust holes / position
5. Place 4 washers in position
6. Pre-assemble standpipe with
4 round-headed screws (M10 × 20mm)
7. Weigh down the cross base with
weights
5
Place sunshade in base
5.3 Set up base on even and stable
surface.
1. Place sunshade in base
2. Tighten the base tube clamp
3. Insert cable
i
Suitable floor mounts are available
from your SUNCOMFORT/GLATZ
dealer.
(350 x 350)
(400 x 400)