Use - Glatz Suncomfort Pendolino Manual De Instrucciones

Use

Bar
handle
Release
handle
Crank
1
1.3
1.4
1.5
Ribs
Cover
Supporting arm
Mast
Base (optional)
Opening the sunshade
1. Remove protective cover
2. Loosen ribbons
3. Extend supporting arm to the opening
stop
4. Completely open the sunshade
through use of the crack
5. Make sure that the inner parts are
engaging
!
The sunshade will be automatically
aligned horizontally. For safe
operation, the inner parts must be
completely engaged.
38 39
2.1
Ribbons
360°
2.3
3.1
3.2
4.1
4.2
2
Positioning of the sunshade
1. Open the release handle, adjust
with the bar handle until the de-
sired inclination is reached
2. Tighten the release handle
3. Open the fixing lever at the base
tube clamp
4. Turn the sunshade to the
requested position
5. Tighten the fixing lever again
3
Closing the sunshade
To close the sunshade, the canopy
needs to be in a horizontal position.
1. Set sunshade horizontally
2. Turn the hand crank until the
sunshade is closed
3.4
3. Open the release handle
4. Pull the supporting arm back
4
Bind/protect the sunshade
1. Pull out / wrap fabric segments
2. Secure the sunshade with the ribbons
4.3
3. Lift the protective cover above the
sunshade section
4. Close the protective cover
!
Position the rod on the side of the
sunshade.