Troubleshooting - vitapur VWD266BLP Manual De Uso Y Cuidado

Troubleshooting

Problem
Water dispenser
is leaking
Water is not hot
or cold enough
Water dispenser
is not dispensing
water
Water dispenser
is noisy
Note:
Do not return this product to the store. For questions on operation, assembly or
parts, please contact Customer Service at 1-877-447-4768 and ask for assistance
Possible Cause
Water was poured directly into
bottle support collar and
overflowed.
All the water in the tank has been
used.
The unit is unplugged.
The circuit breaker in your home
has tripped or the fuse has blown.
Thermostat needs to be adjusted.
Empty water bottle.
Mineral deposits clogging tanks.
Possible air pocket.
Possible ice build up due to
thermostat set too cold.
Bottle is making a gurgling noise
as it fills the tank.
Water dispenser is uneven.
Suggested Solution
Push down on dispenser buttons
to lower the water level.
Replace with full bottle and wait;
30 minutes for water to cool.
Plug it into the outlet.
Reset the breaker or replace the
fuse.
Using a screwdriver, turn the
dial clockwise between lower
setting ( ) for warmer water and
higher setting ( ) for colder water
until the desired temperature is
reached.
Replace with full bottle.
See Cleaning the Reservoirs.
Push down on the dispenser
buttons to prime the unit.
Unplug overnight, then reset. Set
the thermostat to lower setting ( ),
slowly increasing based on your
use and need for cold water.
This is normal.
Make sure the dispenser is on an
even surface that can support its
full weight.
.