Troubleshooting Tips - vitapur VWD2636W-1 Manual De Uso Y Cuidado

SPECIFICATIONS
vWD2636-1
Output per hr:
Internal Tank Capacity:
Heating Temp (approx.):
Cooling Temp (approx.):
Power Consumption (Watts):
Power Consumption (Amps):
voltage

TROUBlESHOOTING TIPS

Problem Possible Cause
Water dispenser
Small pin hole or crack in the bottle, (common with
is leaking
recycled water bottles).
Drain caps are not secure.
Water was poured directly into bottle support collar
and overflowed.
Possible air pocket.
Water is not hot
All the water in the tank has been used.
or cold enough
The unit is unplugged.
Insta-HOT* Feature was not activated.
The circuit breaker in your home is tripped or the fuse
has blown.
Water dispenser Empty water bottle.
is not dispensing
water
Mineral deposits clogging tanks.
Possible air pocket.
Water dispenser
Bottle making a gurgling noise as it fills the tank.
is noisy
Water dispenser is uneven.
ATTENTION: Do not return this product to the store. For questions on operation, assembly or parts,
please contact us at www.greenwayhp.com or 1-866-253-0447.
All manuals and user guides at all-guides.com
Hot
1.3 gal / 5.0 L
Cool 0.1 gal / 0.4 L
Hot
0.16 gal / 0.6 L
Cool 0.2 gal / 0.8 L
201°F / 91°C
42.8°F - 46.4°F / 6°C - 8°C
Hot
1200 W
Cool 65 W
Hot
10.5 A
Cool 1 A
120 V
WARNING: The Water Dispenser heats
and dispenses water to 201˚ F / 91˚ C
which can cause severe burns or
scalding.
DO NOT AllOW CHIlDREN TO USE
THE HOT WATER DISPENSING
BUTTON WITHOUT PROPER AND
DIRECT SUPERvISION.
Suggested Solution
Conduct water bottle leak test outlined
on page 4.
Ensure drain caps are secure.
Drain by pressing dispenser buttons.
Press several times to relieve air pocket and release
to re-set valve.
Replace with full bottle and wait; 60 minutes for water
to cool, 3 minutes for water to heat (after activating
Insta-HOT* feature button).
Plug it into the outlet.
Activate Insta-HOT* Feature by pressing the button.
Reset the breaker or replace the fuse.
Replace with full bottle and wait; 60 minutes for water
to cool, 3 minutes for water to heat (after activating
Insta-HOT* feature button).
See Cleaning the Inside of the Dispenser.
Push down on the dispenser buttons to prime the
unit.
This is normal.
Make sure the dispenser is on an even surface that
can support its full weight.
Child Resistant
Safety Switch
8