Troubleshooting Tips - vitapur Designer Serie Manual De Uso Y Cuidado

Dosificador de agua de sobremesa
Ocultar thumbs Ver también para Designer Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SPECIFICATIONS
Output per hr:
Internal Tank:
Heating Temp (approx.):
Cooling Temp (approx.):
Power Consumption:

TROUBLESHOOTING TIPS

Problem
Water dispenser is leaking
Water is not hot or
cold enough
Water dispenser is not
dispensing water
Water dispenser is noisy
All manuals and user guides at all-guides.com
VWD2636
Hot
1.3 gal / 5.0 L
Cool
0.1 gal / 0.4 L
Hot
0.16 gal / 0.6 L
Cool
0.2 gal / 0.8 L
194°F / 90°C
50°F / 10°C
Hot
1300 W
Cool
75 W
Possible Cause
Small pin hole or crack in the bottle,
(common with recycled water bottles).
Drain cap and silicone seal are not secure.
Water was poured directly into bottle
support collar and overflowed.
All the water in the tank has been used.
The unit is unplugged.
Insta-HOT was not activated.
The circuit breaker in your home is
tripped or the fuse has blown.
Cool water power switch is not
turned on at back of unit.
Temperature limiter tripped.
Empty water bottle.
Mineral deposits clogging tanks.
Possible air pocket.
Bottle making a gurgling noise as it
fills the tank.
Water dispenser is uneven.
WARNING: The Water Dispenser
heats and dispenses water to
194˚ F / 90˚ C which can cause
severe burns or scalding.
DO NOT ALLOW CHILDREN TO USE
THE HOT WATER DISPENSING
BUTTON WITHOUT PROPER AND
DIRECT SUPERVISION.
Suggested Solution
Conduct water bottle leak test outlined
on page 4.
Ensure seal is secure in drain plug and
tighten drain cap.
Drain by pressing dispenser buttons.
Replace with full bottle and wait 30
minutes for the water to heat or cool.
Plug it into the outlet.
Activate Insta-HOT by pressing the button.
Reset the breaker or replace the fuse.
Turn switch to the ON position.
Set power switch to OFF position,
wait 5 minutes, then set power
switch to the ON position. Wait 30
minutes for the water to heat or cool.
Replace with full bottle.
See Cleaning the Reservoirs.
Push down on the dispenser buttons to
prime the unit.
This is normal.
Make sure the dispenser is on an even
surface that can support its full weight.
Childproof
safety
switch
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Vwd2636wVwd2636blkVwd2636bueVwd2636grnVwd2636red

Tabla de contenido