Switching The Dimmer Setting; Switching The Rear Output Setting; Selecting The Digital Attenuator - Pioneer FH-P4000R Manual Del Usuario

Initial Settings

Switching the dimmer setting

To prevent the display from being too bright at
night, the display is automatically dimmed
when the car's headlights are turned on. You
can switch dimmer on or off.
1 Press to select
FUNCTION
Press repeatedly until
FUNCTION
appears in the display.
on or off with 5/∞.
2 Select
DIMMER
Pressing 5/∞ will switch
and off and that status will be displayed (e.g.,
).
DIMMER :ON

Switching the rear output setting

This unit's rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker or subwoofer connection. If you
switch the rear output setting to the subwoofer,
you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
• If you connect a subwoofer to the rear output,
set the output setting to subwoofer.
• Even if you change this setting, there is no
output unless you switch the subwoofer out-
put on (refer to Using subwoofer output on
page 47).
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.
All manuals and user guides at all-guides.com
.
DIMMER
DIMMER
between on
DIMMER
1 Press to select
FUNCTION
Press repeatedly until
FUNCTION
appears in the display.
2 Select full-range speaker or subwoofer
with 2/3.
Pressing 2/3 will switch between
(full-range speaker) and
:FUL
(subwoofer) and that status will be displayed.

Selecting the digital attenuator

When listening to a CD or other source on
which the recording level is high, setting the
equalizer curve level to high may result in distor-
tion. You can switch the digital attenuator to low
to reduce distortion.
• Sound quality is better at the high setting so
this setting is usually used.
1 Press to select
FUNCTION
Press repeatedly until
FUNCTION
appears in the display.
high or low with 2/3.
2 Select
DIG.ATT
Pressing 2/3 will switch
high and low and that status will be displayed
(e.g., ).
DIG.ATT :H
Section
.
REAR SP
REAR SP
REAR SP
REAR SP :S/W
.
DIG.ATT
DIG.ATT
between
DIG.ATT
En
11
51