Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. XXX READY TO ROOM MONITOR shows in display, where XXXX is the unit's name.
6. Press the intercom button on the unit you wish to listen from. The list of registered
units shows in the display.
7. Use the 5 or 6buttons to select the unit you wish to monitor.
8. Press the PAGE soft key to confirm.
9. The first unit will then turn on the microphone and the second unit will turn on
earpiece to monitor sound.
NOTE: Handsets can be on cradle or off cradle for room monitoring to
work.
NOTE: While in room monitoring mode, the listening unit will emit an
alert tone approximately every 4 seconds if there is an incoming call.
You may press the TALK/LINE1/flash1 or TALK/LINE2/flash2 button to quit
room monitor and answer the call.
NOTE: Press the CANCEL soft key or the END/CANCEL button to exit
room monitor mode.

Call Transfer

During an external call, you may transfer the external call from base to handset(s)
or vice versa.
NOTE: To cancel the call transfer, you may press END/CANCEL button or
intercom button on base.
1. Press the intercom button to put the line on hold. LX ON HOLD shows in the display,
where X is the Line number.
. Use the 5 or 6 buttons to select the desired handset or base.
NOTE: If you only have one handset registered in the system, it is
paged automatically.
3. Press the END/CANCEL button to transfer the call. TRANSFERRING FROM XXXX (where
XXXX is the name of the transferring unit) shows in the receiving unit's display.
4. Press the OK soft key on the receiving unit to answer the call.
NOTE: If there is no answer within 2 minutes after transferring the call,
then both units receive a call back notification. If neither unit answers
within 30 seconds, then the external call will be automatically dropped.
8
All manuals and user guides at all-guides.com

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido