Recording On Both Decks In Succession (Relay Recording) - Sony TC-WE825S Manual De Instrucciones

Advanced Recording Operations
To stop dubbing
During
Normal-speed dubbing
High-speed dubbing
z
During high-speed dubbing
Only p is operative.
z
You don't have to adjust the recording level or
select the Dolby NR system during dubbing
Dubbing is automatically performed with the same
recording level and Dolby NR system as the original in
deck A. If, however, you want to monitor the sound
during normal-speed dubbing, set DOLBY NR to match
the tape in deck A (see page 5).
z
You can adjust the pitch of the playback on deck A
(TC-WE825S/WE725 only)
See page 5.
Note
If a TV set is placed near the tape deck, noise may occur
during high-speed dubbing. In that case, turn the television
set off or move it away from the tape deck.
Dubbing only specific portions
You can do this only during the normal-speed
dubbing.
1
Press p on deck A at the portion you want to
skip.
Deck B changes to recording pause.
2
Locate the point you want to resume recording on
deck A, then stop the tape.
3
Press PAUSE P on deck B to resume dubbing.
EN
14
Press
p on deck B
p on either deck
Recording on Both Decks in
Succession (Relay Recording)
You can make a continuous recording that starts on a
cassette in deck A and ends on a cassette in deck B.
DIRECTION MODE ª / ·
RESET MEMORY A COUNTER
g
DIRECTION MODE
RMS
A a
RELAY
RMS/START SET CHECK DISPLAY DECK A
– RMS +
0 (AMS) (AMS) )
Ø ON ø OFF
ª ·
p
PITCH CONTROL CLEAR BACK FRONT
DOLBY NR
PAUSE REC MUTE REC OFF ON ON FILTER
P R r
– +
§
1
Insert blank cassettes into both decks.
Make sure that record-protect tabs on the
cassettes have not been removed.
2
Select the Dolby NR system (see page 7).
3
Set DIRECTION MODE to RELAY.
4
Press REC r on deck A.
Deck A changes to recording pause.
5
Start playing the program source.
6
Adjust the recording level manually, if necessary
(see page 7).
7
Start recording.
To record from
The front side
The reverse side
To stop Relay Recording
During
Press
Recording on deck A p on deck A
Recording on deck B p on deck B
Note
Make sure that · on deck B appears in the display. If it
doesn't, press · on deck B once; otherwise, Relay
Recording stops when the reverse side of the cassette in deck
B finishes.
REC r
B RESET MEMORY
AUTO REC LEVEL
5
4 6
3 7
2 8
1 9
AUTO CAL(STARTP) DUBBING A B
0 10
DECK B A+B REC HIGH/NORMAL
START(DECK BP)
FADER ARL
0 (AMS) (AMS) )
π SYNCHRO
ª ·
p
B C S PAUSE REC MUTE REC PHONES
P R r
§
Press
· on deck A
ª on deck A