Getting Started; Hookup Overview; Audio Component Hookups - Sony TA-FB920R Manual De Instrucciones

Getting Started

Getting Started

Hookup Overview

The amplifier allows you to connect and control the
following audio components. Follow the hookup
procedure indicated for each component that you want
to connect.
To learn the location and name of each jack, see "Rear
Panel Descriptions" on page 12.
DAT deck
MD deck
PROTECTION
U
g
EON LINK TAPE1/DAT TAPE2/MD AUX
EON LINK SPEAKERS BASS TONE
A 0
OFF • B •
A + B
PHONES
– 10 + 10 – 10
Speaker (L)
Before you get started
• Turn off the power to all components before making
any connections.
• Do not connect the mains leads of the various
components until all connections are completed.
• Use the audio connecting cords supplied with each
component for hooking up with the amplifier.
Purchase and use optionally available cords as
required.
• Be sure to make connections firmly to prevent hum
and noise.
• When connecting an audio connecting cord, be sure
to match the R (right) and L (left) jacks of the
amplifier to the R and L jacks on the other
components.
GB
4
Tape deck Tuner
Turntable CD player
VOLUME
INPUT SELECTOR
CD TUNER PHONO
TREBLE BALANCE
TAPE MONITOR
0 SOURCE DIRECT
• • LOUDNESS SUBSONIC 0
SOURCE
Ø ON ø OFF Ø ON ø OFF
TAPE1 • TAPE2
+ 10 LEFT RIGHT
TV or video
Speaker (R)
deck

Audio Component Hookups

Overview
Here you learn how to connect your audio components
to the amplifier.
PHONO y
PHONO
IN SIGNAL
GND
y
L
R
L
R
IN IN IN REC OUT
TUNER CD AUX TAPE2/MD
TUNER CD TAPE2/MD
10
What cords will I need?
Audio connecting cord (not supplied) (2 for each tape deck,
DAT deck, or MD deck; 1 for other components)
White (L)
Red (R)
Hookups
The arrow ç
CD player
Tuner
AUX TAPE1/DAT
IMPEDANCE USE 4–16Ω
A+B USE 8–16Ω
BI WIRE USE 4–16Ω
SPEAKERS
+ – – +
R L
B
L
EON CONTROL
A
R
+ – – +
R L
IN REC OUT IN
IN
TAPE1/DAT
EON CONTROL IN
indicates signal flow.
CD player
Amplifier
L
Ç
R
IN
CD OUTPUT
Amplifier Tuner
L
Ç
R
IN
TUNER OUTPUT
White (L)
Red (R)
L
R
LINE
L
R
LINE