Speaker System Hookups - Sony TA-FB920R Manual De Instrucciones

Tape deck, DAT deck, or MD deck
Amplifier
L
Ç
R
REC OUT IN
TAPE1/DAT
ç
Use the configuration above to connect the OUTPUT and
INPUT jacks of:
—a tape deck or DAT deck to the TAPE1/DAT jacks.
—a tape deck or MD deck to the TAPE2/MD jacks.
Turntable
Amplifier
PHONO
IN
L
Ç
R
Note
To prevent hum, connect the earth lead to SIGNAL GND (y)
on the amplifier.
TV or video deck
Amplifier
L
Ç
R
IN
AUX
EON CONTROL
Amplifier
EON CONTROL
Ç
IN
If your tuner is equipped with an EON CONTROL OUT
terminal, connect it to the EON CONTROL IN terminal on
the amplifier to allow use of the EON (Enhanced Other
Networks) function of the RDS (Radio Data System) (see
page 8).
Tape deck
L
R
LINE LINE
OUTPUT INPUT
Turntable
TV or video deck
L
R
LINE
OUTPUT
Tuner
EON CONTROL
OUT

Speaker System Hookups

Overview
Here you learn how to connect speakers to the
amplifier. You can connect two pairs of speakers,
SPEAKERS A and B.
SPEAKERS A SPEAKERS B
PHONO
IN SIGNAL IMPEDANCE USE 4–16Ω
A+B USE 8–16Ω
GND
y BI WIRE USE 4–16Ω
L
SPEAKERS
+ – – +
R L
R
B
L L
A
R R
+ – – +
R L
IN IN IN REC OUT IN REC OUT IN
TUNER CD AUX TAPE2/MD TAPE1/DAT
What cords will I need?
Speaker cord (not supplied) (1 for each speaker)
(+)
(–)
Twist the stripped ends of the cord about 15mm. Be sure to
match the speaker cord to the appropriate terminal on the
components: + to + and – to –. If the cords are reversed, the
sound will be distorted and will lack bass.
Hookups
}
]
Getting Started
EON CONTROL
IN
(+)
(–)
}
]
GB
5