Important - BQS BTG 0123 Manual De Uso

IMPORTANT

Read the instructions carefully before
installing the child seat in the vehicle.
1. Only suitable if the approved vehicle has been fitted with three-point safety
belts that meet ECE standard Nº 16 or equivalent.
2. This child seat must be used with a harness system suitable for children
weighing between 0 kg to 18 kg.
3. This child seat can be used without harness for children weighing between 15
kg to 36 kg.
4. Under no circumstances should the safety seat be installed in the front seat
of the car opposite the direction of travel if the car is equipped with an active
airbag.
5. Ensure that the part of any abdominal belt or strap should rest as low as
possible over the child's hips, on both sides.
6. Please read the instructions carefully, as incorrect installation could result in
serious injury. If any injuries should occur as a result of incorrect installation, the
manufacturer will accept no liability.
7. This child restraint system complies with the rules of Regulation ECE 44/04 and
can be installed in most vehicles equipped with 3-point seat belts aligned to
ECE Regulation 16. Under no circumstances shall this seat be fitted only with a
2-point lap belt.
8. Please never use the safety seat without its cover or without the harness
protectors.
9. Fastening a child dressed in outerwear could reduce the efficiency of the
restraint system.
10. Make sure to protect the child safety seat from direct sunlight as it could heat
up and hurt the child.
11. Child seats or harness accessories that are damaged or have been used
incorrectly must be replaced.
12. Do not leave heavy objects inside the car, as these may injure the child in the
event of an accident.
13. Make sure that the buckle is correctly fastened so that the child can be quickly
freed in case of emergency.
14.The safety seat's rigid and plastic elements should be positioned and installed
so that they cannot be trapped by a moving seat or a door during everyday
use of the vehicle.
www.babyqs.com
27