Cleaning And Maintenance - BQS BTG 0123 Manual De Uso

7.2 Installing the child seat forward facing. Group 2/3
WARNING!
In order to fasten the child to the safety seat, please use only the 3 point
vehicle's belt.
WARNING!
Make sure the 5-point harness and harness buckle have been correctly
removed.
(G)
1. Pull the lever
2. Place the seat in the seat in the direction of travel (fig. 7.6).
3. Place the child in the seat. Pull the vehicle safety belt and pass it in front of the
child until it reaches the vehicle seat belt buckle (fig. 7.7).
IMPORTANT!
Make sure the belt is not twisted.
4. Insert the clasp into the vehicle seat buckle. You should hear a click (fig. 7.7).
5. Make sure the abdominal belt pass by the lower guides
seat (fig. 6.7). Verify that the straps are taut and not twisted.
6. Pass the diagonal part of the car belt through the guide
extended and not twisted.
7. Make sure the diagonal part of the belt passes over the child's collar bone and
not the neck.
IMPORTANT!
The part of the abdominal belt should rest as low as possible over the
child's hips, on both sides.

8. CLEANING AND MAINTENANCE

Removing
1. For washing the seat fabric cover, remove the harness and the safety buckle
following the steps described in the chapter 6.
2. Unbutton the push buttons that are on both sides of the child safety seat.
Cleaning the seat
1. Wash the straps and plastic parts with neutral detergent and warm water.
2. Ensure that no soap enters the buckle or metal parts.
3. Do not use chemicals or bleach on any part of the chair.
4. Dry thoroughly before use.
3. Carefully remove the seat cover.
forward and adjust the angle of recline to position 1, (fig. 7.5).
(G)
on both sides of the
(P)
. Make sure it is fully
www.babyqs.com
33