Description - Hilti SFL 14-A Manual De Instrucciones

Obligation signs
Wear eye
protection.
en
Symbols
Read the Volts
operating
instructions
before use.

2. Description

2.1 Use of the product as directed
The appliance is designed to be used as a source of light on construction sites.
The appliance is manufactured from high-grade, impact-resistant plastic. The battery and charger are not
supplied with the lamp.
Keep the appliance out of reach of children.
Take the influences of the surrounding area into account. Do not use the power tool or appliance where there
is a risk of fire or explosion.
The appliance may be used only in a dry environment.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
To avoid the risk of injury, use only genuine Hilti tools and accessories.
Modification of the appliance or tampering with its parts is not permissible.
2.2 Li ion battery charge status
LEDs light constantly
LED 1,2,3,4
LED 1,2,3
LED 1,2
LED 1
-
-
The lamp blinks when battery power is too low. If this occurs, remove the battery and insert a charged battery.
10
Printed: 31.07.2012 | Doc-Nr: PUB / 5071526 / 000 / 00
All manuals and user guides at all-guides.com
Return waste
material for
recycling.
LEDs blink
-
-
-
-
LED 1
LED 1
Location of identification data on the appliance
The type designation can be found on the type iden-
tification plate at the base of the appliance and the
serial number on the side of the casing. Make a note
of this data in your operating instructions and al-
ways refer to it when making an enquiry to your Hilti
representative or service department.
Type:
Generation: 01
Serial no.:
Charge status C
C
50 %
25 %
10 %
C < 10 %
Battery overheated
75 %
C < 75 %
C < 50 %
C < 25 %