Kit Assembly - Metra 99-8210 Manual Del Usuario

DIN radio provision with pocket
1. Remove the metal DIN sleeve from the
aftermarket radio.
2. Slide the sleeve into the radio housing
and secure by bending the metal locking
tabs outward. (Figure A)
3. Slide the radio back into the sleeve until
it clicks in. (Figure B)
4. Locate the factory wiring harness in
the dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS.
5. Re-connect the negative battery
terminal and test the unit for proper
operation.
6. Reassemble the dash in reverse
order of disassembly

KIT ASSEMBLY

(Figure A)
(Figure B)
ISO DIN radio provision with pocket
1. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
2. Mount the ISO brackets to the radio
with the screws supplied with the radio.
(Figure A)
3. Slide the radio into the radio housing
until the side clips engage. Snap the
ISO trim plate into the radio housing.
(Figure B)
4. Locate the factory wiring harness in
the dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS.
5. Re-connect the negative battery
terminal and test the unit for proper
operation.
6. Reassemble the dash in reverse order of
disassembly.
(Figure A)
(Figure B)
REV. 7/2/2021 INST99-8210
3