Cleaning The Wire Guide; Risk Of Injury; Cleaning The Torch Neck - Abicor Binzel MIG Robo Manual Del Usuario

9 Maintenance and cleaning

9.4 Cleaning the wire guide

1 Unscrew the cable assembly on the machine side and lay it out in a stretched position.
2 Unscrew the nut and pull out the liner.
WARNING

Risk of injury

Serious injuries caused by parts swirling around.
• When cleaning the wire guide with compressed air, always wear personal protective
clothing, in particular safety goggles.
3 Clean the wire conduit from both sides with compressed air.
4 Slide the adjusted liner into the wire conduit and secure with a nut.

9.5 Cleaning the torch neck

To increase the system availability of the welding robot, ABICOR BINZEL offers automated
torch cleaning.
1 Remove the gas nozzle.
2 Remove the welding spatter and spray with ABICOR BINZEL anti-spatter fluid.
3 Check the wear parts for visible damage and replace them if necessary.
4 Replace the equipment kit when worn or soiled.
5 Clean the separating point and O-rings with silicone-free seal grease.
6 Test the TCP in the alignment jig after every use or following a collision.
EN - 16
All manuals and user guides at all-guides.com
MIG/MAG ROBO welding torch