Maintenance Intervals - Abicor Binzel MIG Robo Manual Del Usuario

9 Maintenance and cleaning

9.1 Maintenance intervals

NOTICE
• The specified maintenance intervals are standard values and refer to single-shift
operation.
Observe the provisions of EN 60974-4 Inspection and testing during the operation of arc
welding equipment plus any national laws and regulations.
• We recommend basic cleaning once a week. The type and frequency of cleaning shall be
determined and established by the system operator of the welding system.
• Clean weld spatter from the torch head daily. In the case of heavy weld spatter build-up,
clean during each welding break.
9.2 Liner
NOTICE
• New and unused liners must be shortened to the actual length of the cable assembly.
1
1 Torch head
2 Central connector
Fig. 3 Shortening the spiral liner
1 Disassemble the equipment parts from the torch head (1).
2 Loosen the nut (3) from the central connector (2).
3 Lay out the cable assembly in a stretched position.
4 Push the liner through the wire conduit until the retaining nipple (4).
5 Hand-tighten the nut (3).
6 Cut off any excess length (x) flush with the torch head and pull out the liner again.
EN - 14
All manuals and user guides at all-guides.com
3 Nut
MIG/MAG ROBO welding torch
2
4
4 Retaining nipple
3