Tabla de contenido
Publicidad
Step 13
1
D12
Groove
Insert the DRAWER SIDES (D12 and D13) at an angle into
å
the slot at each end of the LEFT DRAWER FRONT (O2).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Fasten the DRAWER BACK (D72) to the DRAWER SIDES (D12
å
and D13). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
Repeat this step for the remaining drawers.
å
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D13
O2
D72
D12
D968
VIEW THE T-LOCK BOX VIDEO
2
U n
fi n
s u
r f a
D12
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D968) into the grooves
å
in the DRAWER SIDES (D12 and D13) and LEFT
DRAWER FRONT (O2).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(16 used in this step)
D13
409242
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
i s h
e d
c e
D968
D13
O2
30S
Page 17
Publicidad
Tabla de contenido
