25 6.5 Raising Vehicle On Runway; 25 6.6 During Work On Vehicle - Beissbarth VLH 4440 Manual Original

en 36 | VLH 4440 | Operation
6.5 Raising vehicle on runway
DANGER – Risk of vehicle falling or tilting
Risk of (fatal) injury on lifting (or raising) the
runway.
¶
Make sure the vehicle is correctly
positioned and secured against rolling.
¶
Make sure there is no-one in the vehicle or
in the area of the lifting platform.
¶
Keep away from the lifting platform.
¶
Observe the lifting platform and vehicle.
¶
Pay attention to even lowering of both
runways when moving to the setting-down
position.
1. Keep the "Lift" button (o) pressed.
 The runway moves upwards for as long as the
button is pressed.
2. Raise the runway to slightly above the required end
position and then release the button.
 The detent pins are positioned in front of the
snap latches.
3. Keep the "Set down" button pressed.
 The detent pins are extended.
 The runway moves downwards until all four
detent pins are resting in the snap latches.
"
The runway is raised and locked.
i
The runways will tilt on lowering if the four detent
pins are not properly engaged. The lowering
operation will then be stopped by the slack cable
safety system.
Remedy: Raise again, press the setting-down button
and repeat the setting-down operation.
|
1 692 846 001 2017-04-27
6.6 During work on vehicle
DANGER – Risk of vehicle falling or tilting
Risk of (fatal) injury whilst using lifting platform.
¶
Do not walk under the vehicle if it is not
firmly positioned on the runways.
¶
Avoid subjecting the vehicle to severe
vibration.
¶
Never cause the vehicle or lifting platform
to vibrate.
¶
Always use safety devices if heavy
components (e.g. engine, transmission) are
being removed or attached. Fit the safety
devices to reach towards the vehicle rather
than lowering the vehicle onto the safety
devices.
Beissbarth GmbH