Disassembly And Replacement; Disposal; Environmental Protection; Extension And Conversion - Bosch Rexroth SE352 Manual De Instrucciones

28/88 Bosch Rexroth AG
11 Disassembly and
replacement
Disassembling the SE352/SE352M
CAUTION
Removing the SE352/SE352M
control unit under voltage
Damage to the SE352/SE352M
control unit!
y Always switch off the power
supply for the relevant system
component before disassem-
bling the SE352/SE352M con-
trol unit.
y For reasons of safety, the
SE352/SE352M control unit
may only be inserted or re-
moved at the earliest 10 sec-
onds after the power supply to
the BT356 card rack or SB35x
system box has been switched
off.
Proceed as follows to disassemble the
SE352/SE352M control unit:
1. Switch off the power supply to the
BT356 card rack or SB35x system box
and allow for a discharging time of
10 seconds.
2. Loosen the knurled screws on the front
side and pull out the SE352/SE352M
control unit.
3. Install a corresponding dummy panel, if
necessary
.
SE352/SE352M | 3 609 929 B61/2008-09
Tab. 5: Dummy panels
Dummy panel
Type
for
BP351 Servo amplifier
BP352 Controller and
servo amplifier
12

Disposal

Environmental protection

Careless disposal of the SE352/SE352M
control unit could lead to pollution of the
environment.
Therefore dispose of the device in
accordance with the currently applicable
regulations in your country.
You can also send the device to Bosch
Rexroth for disposal.
13 Extension and
conversion
Do not convert the SE352/SE352M control
unit.
14

Troubleshooting

Malfunctions and information on errors are
displayed in the tightening system via the
BS350.
If you are not be able to remedy an occurring
defect, please contact one of the addresses
that you can find under
www.boschrexroth.com or in the address
directory in chapter "16 Service and sales"
on page 30.
Order number
3 608 878 058
3 608 878 060