Transport And Storage; Assembly - Bosch Rexroth SE352 Manual De Instrucciones

24/88 Bosch Rexroth AG
Slot for the mass storage (X6C1)
This interface is intended for the use of the
CF350 mass storage.
ATTENTION
Damage due to improper assembly!
Damage to the connections
y Only use mass storage from Rexroth.
y Insert the CF350 mass storage into the
SE352/SE352M control unit with the
plug-in connections facing the front, so
the "Rexroth" product label (front side of
the card) is visible.
5

Transport and storage

For storing and transporting the product,
always observe the ambient conditions
specified in the technical data (see
"Technical data" on page 29).
6

Assembly

When installing the product, always observe
the ambient conditions specified in the
technical data (see "Technical data" on
page 29).
SE352/SE352M | 3 609 929 B61/2008-09
Installing SE352/SE352M control unit
CAUTION
Risk of damage to persons
and property!
Assembly of the SE352/SE352M
control unit requires basic me-
chanical and electrical knowl-
edge.
y Only qualified personnel (see
"Personnel qualifications" on
page 18) are authorized to as-
semble the SE352/SE352M
control unit.
y Measures to prevent electro-
static discharge (ESD protec-
tion) must be undertaken to
protect the module and system
components during all assem-
bly work.
CAUTION
Risk of injuries when
assembling under voltage!
If you do not switch off the power
supply before assembling the
SE352/SE352M control unit, you
may be injured or the device or
system components may be dam-
aged.
y Switch off power supply for the
relevant system component be-
fore assembling the SE352/
SE352M control unit.