Oster BVSTEM8100 Manual De Instrucciones página 45

Cleaning the automatic milk dispensing system
Note: it is important to do this daily to make sure the automatic milk frother works
properly.
1. Place a cup under the spout.
2. Fill the milk container with fresh water.
3. Connect the milk container to the espresso maker as described in "Preparing Latte"
section
4. Press the "Manual Clean" button.
5. The espresso maker will dispense hot water and steam to wash the dispensing tube
and milk spout.
6. Press the button again to stop the water.
7. Take apart the milk dispensing system by following procedure. Clean them with fresh
water. Then insert the milk dispensing system into slot. (see figures below)
Step 1: Remove the spout cover and then take out the milk dispensing system.
Step 2: Take apart the milk dispensing system into two parts and rinse with clean water
Step 3: Assemble the milk dispensing system back to its original placement.
Step 4: Insert the milk dispensing system to the slot.
Eng lish -18