Installation, Electrical - ProMinent DULCOTEST ICT 1-IMA-1 m Instrucciones De Servicio

ProMinent ®
6

Installation, electrical

IMPORTANT
• Connect the sensor only when the mains power supply is
switched off.
• Do not shorten the connection lead. The measurement result
will otherwise be incorrect. The warranty is void in this case.
• Install according to the relevant national directives.
• Always use correct cable ferrules.
Break open the large opening in the middle of the base of the
®
DULCOMETER
®
DULCOMETER D1C, part 1)
Screw in a 13.5 skintop connector (supplied with the
DULCOMETER ® D1C controller)
Connect the sensor to the DULCOMETER
accordance with the wiring diagram (see next page).
Tighten the skintop connector until watertight, ensuring that there
is still sufficient cable inside the DULCOMETER
Installation, electrical
D1C housing (see Operating instructions
® D1C controller in
®
D1C controller.
31